• High Build Quality
• The device also can be used as a signal generator for electric speed controller (ESC), then you can test your motor system without using a transmitter and receiver.
• There are 3 modes to check servos or ESC:
  • Manual mode: turn the knob with different speed, check the reaction time.
  • Neutral mode: make the servo go back to the neutral point.
  • Automatic window wiper mode: make the servo swing like a window wipers in the biggest angle.
• It can connect 1-3 servos simultaneously and test such as 1-3 servos consistency and so on.
• You can also connect 1-3 ESC to test and compare their reaction time respectively.
• It can connect 3 servos of the CCPM helicopters and select servos.
• It can also connect the servo of airplanes install the steering-box and adjust planes by using such as the neutral mode and so on.

Technical Data:

• Voltage consumption: DC4.8-6V
• Size: 48 x 42 x 17mm
• Item size: 48*42*17 mm
• Net weight: 7g
• Package weight: 13g

Package Contains:

• Multi Servo Tester x 1 Pc.

Motor shield for Arduino for driving DC Motor, Servo Motor, Stepper Motor

2 Connections for Servo Motor.

4 H-Bridges: L293D chipset provides 0.6A per bridge (1.2A peak) with thermal shutdown protection, internal kickback protection diodes. Can run motors on 4.5VDC to 25VDC.

Up to 4 bi-directional DC motors with individual 8-bit speed selection (so, about 0.5% resolution)

Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping

Pull down resistors keep motors disabled during power-up

2-pin terminal block and jumper to connect external power, for separate logic/motor supplies

Tested compatible with Arduino UNO, Mega 1280 & 2560, Diecimila and Duemilanove

Made In India.

Item included:

1. Motor Driver Shield For Arduino – 1 No.

2. User Manual – 1 No.

3. 6X1 Header Pin – 3 Nos. ( For sensor interfacing)